1ST ROW INBOARD SIDESHIELD - LEFT HAND (Remove and Replace)
Correction code
1307010302
FRT
0.10
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Open the LH front door and lower the LH front window.
- Move the LH front seat backward.
- Open the RH rear door and lower the RH rear window.
-
Release the front clips (x3) that
attach the inboard side shield to the seat inner seat rail.
NoteRelease the lower clips first and then the upper positioning clip. Do not fully remove the inboard side shield for the risk of damage.
- Pull the rear portion of the inboard sideshield outward, release the clips (x5), and then remove the inboard sideshield from the drive seat.
Install
-
Apply light pressure to the rear of
the inboard sideshield to install the clips (x5) into position.
NoteUse a flashlight to help ensure that the trim and the clips are not damaged during installation.
-
Install the front clips (x3) that attach the inboard side shield to the seat inner
seat rail.
NoteInstall the upper positioning clip first and then the lower clips.NoteUse a flashlight to help ensure that the trim and the clips are not damaged during installation.
- Raise the RH rear window and close the RH rear door.
- Return the LH front seat to its original position.
- Raise the LH front window and close the LH front door.