Cover - Busbar Module 2 To Pyrofuse - Ancillary Bay (Model Y L) (Remove and Replace)
Correction code
16300502102
FRT
2.64
NOTE: Unless
otherwise explicitly stated in the procedure, the correction code and its
associated FRT reflect all of the work required to perform this procedure,
including the linked procedures. Do not stack correction
codes unless explicitly told to do so.
NOTE: See Flat Rate Times to
learn more about FRTs and how they are created.
NOTE: See Personal Protection to make
sure you are wearing proper PPE when performing the procedure below.
NOTE: See Ergonomic Precautions for safe and healthy
working practices.
Remove
-
Remove the PCS2 Lite. See PCS2 Lite - Ancillary Bay (Model YL) (Remove and Install).
NoteDuring removal, certain steps require extra care. See the animation(s) for detailed guidance.
-
Remove the HV joint insulator for
positive busbar module 2 to pyrofuse.
-
Release the clips (x4) securing the positive busbar module 2 to pyrofuse cover.
Replace
-
Fasten the clips (x4) securing the positive busbar module 2 to pyrofuse cover.
-
Install the HV joint insulator for positive busbar module 2 to pyrofuse.
- Install the PCS2 Lite. See PCS2 Lite - Ancillary Bay (Model YL) (Remove and Install).