2026-08-09

Window Regulator Motor - Rear - LH (Remove and Install)

Correction code 1150010061 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Torque Specifications

Table 1. Torque Specifications: Window Regulator Motor - Rear - LH (Remove and Install)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws (x3) that attach the window motor to the closeout panel
3.5 Nm (2.6 lbs-ft)
  • Torx T25 socket
 Reuse

Remove

  1. Remove the LH rear door trim. See Door Trim - Rear - LH (Remove and Install).
  2. Release the connector lock, and then disconnect the LH rear window regulator motor connector.
  3. Remove the screws (x3) that attach the LH rear window motor to the closeout panel, and then remove the motor from the panel.
    Tip
    Use of the following tool(s) is recommended:
    • Torx T25 socket

Install

  1. Position the LH rear window regulator motor onto the closeout panel, and then install the screws (x3) that attach the window motor to the closeout panel.
    3.5 Nm (2.6 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • Torx T25 socket
  2. Connect the LH window motor electrical connector, and then engage the connector lock.
  3. Install the LH rear door trim. See Door Trim - Rear - LH (Remove and Install).