2026-08-09

Noise Absorber - Motor Bay - Rear (Remove and Replace)

Correction code 1201010202 FRT 1.74 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Remove

  1. Open all doors and lower all windows and .
  2. Partially lower the rear subframe and drive unit assembly. See .
    Note
    Do not overstrain these components, the dampers and brake calipers are still connected.
  3. Release the clips (x4) that attach the rear motor bay noise absorber to the vehicle, and then remove the rear motor bay noise absorber.

Install

  1. Position the rear motor bay noise absorber to the vehicle, and then install the clips (x4) that attach the rear motor bay noise absorber to the vehicle.
  2. Install the rear subframe assembly. See .
  3. Raise all windows and close all doors.