2025-03-12

CONSOLE - REAR AIR VENT PAN (Remove and Install)

Correction code 1519021501 FRT 0.00 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: CONSOLE - REAR AIR VENT PAN (Remove and Install)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x2) that attach the air wave assembly to the rear display module
1.2 Nm (.9 lbs-ft)
  • Torx T20 socket
  • Torque wrench with angle measurement
Replace 1096312-00-A
Screws (x2) that attach the air wave assembly to the vent cover panel
0.8 Nm (7 lbs-in)
  • Torx T20 socket
  • Digital Torque Screwdriver 0.10Nm - 2.0Nm
Reuse

Remove

  1. Remove the rear end module assembly. See Touchscreen - Rear Display (Remove and Install).
    Informational PurposesAn informational icon, calling your attention
    Note
    It is not necessary to remove the rear display from the rear end module assembly.
  2. Use a plastic trim tool to release the clips and tabs that attach the USB bezel to the vent cover panel.
  3. Disconnect the USB connector, and then remove the USB bezel from the center console.
  4. Remove and discard the bolts (x2) that attach the air wave assembly to the rear display module.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
    • Torque wrench with angle measurement
  5. Remove the screws (x2) that attach the air wave assembly to the vent cover panel.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm
  6. Release the clips (x3) that attach the vent cover panel air wave assembly, and then remove the panel from the vehicle.

Install

  1. Position the vent cover panel to the air wave assembly, and then install the clips (x3) that attach the panel air wave assembly.
  2. Install the screws (x2) that attach the air wave assembly to the vent cover panel.
    0.8 Nm (7 lbs-in)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm
  3. Install new bolts (x2) that attach the air wave assembly to the rear display module.
    1.2 Nm (.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
    • Torque wrench with angle measurement
  4. Connect the USB connector.
  5. Install the clips and tabs that attach the USB bezel to the vent cover panel.
  6. Install the rear end module. See Touchscreen - Rear Display (Remove and Install).