2026-08-09

Ball Stud Bracket (Remove and Replace)

Correction code 1133050102 FRT 0.05 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-01-26: Update the description to clarify the liftgate ball stud bracket must be replaced.

Torque Specifications

Table 1. Torque Specifications: Ball Stud Bracket (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that attaches the LH liftgate ball stud to the vehicle
20 Nm (14.7 lbs-ft)
  • 13 mm socket
 Reuse

Remove

  1. Open the liftgate.
  2. Use a telescoping hood prop to support the liftgate.
    Note
    Place a towel in-between the prop and the liftgate to prevent damage to the liftgate trim.
  3. Release the LH upper power strut clip, separate the LH liftgate power strut from the ball stud, and then move the power strut aside.
  4. Remove the bolt that attaches the LH liftgate ball stud to the vehicle, and then remove the ball stud from the vehicle.
    Note
    Discard the ball stud after remove.
    Tip
    Use of the following tool(s) is recommended:
    • 13 mm socket

Install

  1. Position the LH liftgate ball stud into the vehicle, and then install the bolt that attaches the new ball stud to the vehicle.
    20 Nm (14.7 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 13 mm socket
  2. Install the clip that attaches the LH upper power strut to the ball stud.
  3. Remove the liftgate support.
  4. Close the liftgate.