2025-04-13

Instrument Panel - Driver Footwell Duct - RHD (Remove and Replace)

Correction code 1405031002 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the passenger footwell cover. See Instrument Panel - Passanger Footwell - RHD (Remove and Replace).
  2. Remove the screw that attaches the glove box assembly to the IP carrier.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
  3. Release the clip that attaches the passenger footwell duct to the vehicle.
  4. Maneuver the passenger footwell duct out from between the IP carrier and the glove box.

Install

  1. Maneuver the passenger footwell duct into position between the IP carrier and the glove box, and then install the duct onto the HVAC assembly.
  2. Install the clip that attaches the passenger footwell duct to the vehicle.
  3. Install the screw that attaches the glove box assembly to the IP carrier.
    2.3 Nm (1.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
  4. Install the passenger footwell cover. See Instrument Panel - Passanger Footwell - RHD (Remove and Replace).