2024-12-24

Panel - Top Face - Center Console (Remove and Replace)

Correction code TBD FRT 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Panel - Top Face - Center Console (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws (x4) that attach the top face panel to the center console
1.2 Nm (.9 lbs-ft)
  • Torx T20 bit
  • Digital Torque Screwdriver 0.10Nm - 2.0Nm
Reuse

Remove

  1. Remove the center console rear end panel. See CONSOLE - END PANEL (Remove and Replace).
  2. Remove the center console LH front side panel. See CONSOLE SIDE PANEL LEFT HAND (Remove and Replace).
  3. Remove the center console LH and RH rear side panels. See Side Panel - Rear - Center Console - LH (Remove and Replace).
  4. Remove the center console RH front side panel. See CONSOLE SIDE PANEL RIGHT HAND (Remove and Replace).
  5. Remove the phone dock surround. See Surround - Phone Dock - Center Console (Remove and Replace).
  6. Remove the LH and RH hockey sticks. See 2.0 - CONSOLE - H-DÉCOR (Remove and Replace).
  7. Remove the screws (x4) that attach the top face panel to the center console.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm
  8. Release the clips (x4) and remove the top face panel from the center console.

Install

  1. Secure the clips (x4) to install the top face panel to the center console.
  2. Install the screws (x4) that attach the top face panel to the center console.
    1.2 Nm (.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm
  3. Install the LH and RH hockey sticks. See 2.0 - CONSOLE - H-DÉCOR (Remove and Replace).
  4. Install the phone dock surround. See Surround - Phone Dock - Center Console (Remove and Replace).
  5. Install the center console RH front side panel. See CONSOLE SIDE PANEL RIGHT HAND (Remove and Replace).
  6. Install the center console LH and RH rear side panels. See Side Panel - Rear - Center Console - LH (Remove and Replace).
  7. Install the center console LH front side panel. See CONSOLE SIDE PANEL LEFT HAND (Remove and Replace).
  8. Install the center console rear end panel. See CONSOLE - END PANEL (Remove and Replace).