2024-12-24

Headlamp Fascia Bracket - LH (SAE) (Remove and Replace)

Correction code 1740020802 FRT 0.55 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Torque Specifications

Table 1. Torque Specifications: Headlamp Fascia Bracket - RH (SAE) (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws (x4) that attach the LH fascia bracket to the headlamp assembly
1.8 Nm (1.3 lbs-ft)
  • Torx T25 socket
 Reuse

Remove

  1. Remove the front fascia. See Front Fascia (Remove and Install).
  2. Remove the screws (x4) that attach the LH fascia bracket to the headlamp assembly, and then remove the bracket from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T25 socket

Install

  1. Position the LH fascia bracket to the headlamp, and then install the screws (x4) that attach the LH fascia bracket to the headlamp assembly.
    1.8 Nm (1.3 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Before installation, please verify that the four rubber pads on the back of the bracket are present and not missing.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T25 socket
  2. Install the front fascia. See Front Fascia (Remove and Install).