2026-10-23

Audio Speakers - Audio Speaker - Full Range - 100mm (Remove and Replace)

Correction code 2121012022 FRT 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Torque Specifications

  • 2026-07-02: Added special tooling part number.
Table 1. Torque Specifications: Audio Speakers - Audio Speaker - Full Range - 100mm (Remove and Replace) / Audio Speakers - Audio Speaker Full Range 100MM - Center  (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Instrument panel speaker screws
2.3 Nm (1.7 lbs-ft)
  • SET, 1/2" CUT BIT. (78 PCS DOUBLE END MINI RATCHET)
  • Wiha Torque Screwdriver 0.8-5 Nm screwdriver (installation only)
 Reuse
Equipment:
  • 1450424-00-B - 78PCS DOUBLE END MINI RATCHET BIT SET

Remove

  1. Open both front doors and lower both front windows.
  2. Remove the LH and RH upper A-pillar trims. See Trim - A-Pillar - Upper - LH (Remove and Replace).
  3. Remove the wrap around assembly. See Speaker Grille - Instrument Panel (Remove and Install).
    Note
    During removal, certain steps require extra care. See the animation(s) for detailed guidance.
  4. Remove the LH instrument panel speaker screws (x3).
    Tip
    Use of the following tool(s) is recommended:
    • 1450424-00-B - 78PCS DOUBLE END MINI RATCHET BIT SET
    • Torx T20 bit
  5. Release the speaker connector, and then remove the LH instrument panel speaker.