2024-12-24

Bumper Stop - Liftgate - LH (Remove and Replace)

Correction code TBD FRT 0.05 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Open the liftgate.
  2. Use a combi wedge to release the tabs (x4) that attach the LH bumper stop to the liftgate, and then remove it from the vehicle.

Install

  1. Install the tabs (x4) that attach the LH bumper stop to the liftgate.
  2. Close the liftgate.
  3. Verify the flushness from the liftgate to the rear fascia assembly, and adjust as necessary.
    Informational PurposesAn informational icon, calling your attention
    Note
    Refer to Toolbox article 8199800 for additional information on bump stop adjustment.