High Voltage 3-Phase Harness - AC Inlet (Remove and Install)
Correction code
4450010102
FRT
0.60
NOTE: Unless
otherwise explicitly stated in the procedure, the correction code and FRT
listed above reflect all of the work required to perform this procedure,
including the linked procedures. Do not stack correction
codes unless explicitly told to do so.
NOTE: See Flat Rate Times
to learn more about FRTs and how they are created.
NOTE: See Personal Protection
to make sure you are wearing proper PPE when performing the procedure
below.
NOTE:
See Ergonomic Precautions for
safe and healthy working practices.
Remove
- Perform Vehicle HV Disablement Procedure. See Vehicle HV Disablement Procedure.
- Remove the LH trunk side trim. See Trunk Side Trim LH - Rear Under Body (Remove and Replace).
-
Disconnect charge port logic
connector.
-
Disconnect AC inlet harness from
charge port.
-
Disconnect AC chargeport inlet harness
from HV header.
-
Release LH body harness from rear body
and move aside.
-
Remove HV inlet harness from
vehicle.
Install
-
Install HV inlet harness into vehicle.
-
Connect 3PH chargeport inlet harness to HV header.
-
Install LH body harness onto rear body.
-
Connect AC inlet harness from charge port.
-
Connect charge port logic connector.
- Install the LH trunk side trim. See Trunk Side Trim LH - Rear Under Body (Remove and Replace).
- Connect LV power. See LV Power (Disconnect and Connect) (Modify).
- Install the 2nd row lower seat cushion. See Seat Cushion - 2nd Row (Remove and Replace).
- Move LH and RH front seat to original position.
- Raise all windows.
- Close liftgate and all four doors.