2.0 CONSOLE - CUP HOLDER LOWER ASY (Remove and Replace)
Correction code
1519020702
FRT
0.25
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Remove the center console rear end panel. See CONSOLE - END PANEL (Remove and Replace).
- Remove both LH and RH rear side panel from center console assembly. See Side Panel - Rear - Center Console - LH (Remove and Replace).
- Remove both LH and RH hockey stick from center console assembly. See 2.0 - CONSOLE - H-DÉCOR (Remove and Replace).
- Remove the top face panel assembly from center console. See Panel - Top Face - Center Console (Remove and Replace).
- Close cup holder sliding lid.
- Remove the cup holder.
Install
- Install the cup holder.
- Install the top face panel assembly to center console. See Panel - Top Face - Center Console (Remove and Replace).
- Install both RH and LH hockey stick to center console assembly. See 2.0 - CONSOLE - H-DÉCOR (Remove and Replace).
- Install both RH and LH rear side panel to center console assembly. See Side Panel - Rear - Center Console - LH (Remove and Replace).
- Install the center console rear end panel. See CONSOLE - END PANEL (Remove and Replace).