VIN LABEL (Remove and Replace)
Correction code
1020030202
FRT
2.05
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Remove the windshield. See WINDSHIELD - LEFT HAND (Remove and Replace).
- Remove the old VIN label from the body.
- Use glue cleaner and IPA wipers to clean off any remaining adhesive, and allow at least one minute to dry.
Install
-
Install the new VIN label to the body.
NoteAlign the hash marks at the top of the VIN label with the V-notch in the body, and position the top edge of the VIN label in alignment with the wider notches.
- Install the windshield. See WINDSHIELD - LEFT HAND (Remove and Replace).