2025-03-12

SEAL- GEARBOX- INVERTER - 3DU (Remove and Replace)

Correction code 3920010502 FRT 2.55 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 1056154-00-A Anti Static Mat /w Wrist Grounding Cord and Wrist Strap

Remove

  1. Remove the front drive unit inverter. See .
  2. Carefully place the inverter on an ESD safe mat (1056154-00-A), and then remove the front drive unit inverter gasket from the inverter.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not place the inverter facing downwards on the circuit board as it is fragile.

Install

  1. Install front drive unit inverter seal.
  2. Inspect gap pad of the inverter,verify the gap pad is fully attached and covering the discharge resistor array and no resistors should be visible.
    Informational PurposesAn informational icon, calling your attention
    Note
    Replace gap pad if it does not match the criteria.
  3. Install the front drive unit inverter. See .