2025-03-12

FILL/DRAIN PLUG (Remove and Replace)

Correction code 4001010402 FRT 0.00 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: FILL/DRAIN PLUG (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Nut that attaches the fill plug to the drive unit
15 Nm (11.1 lbs-ft)
  • 8 mm socket
  • Ratchet/torque wrench
 Reuse

Remove

  1. Remove the mid aero shield. See Aero Shield - Middle (Remove and Replace).
  2. Remove the nut that attaches the fill plug to the drive unit.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 8 mm socket
    • Ratchet/torque wrench

Install

  1. Secure oil fill plug to the drive unit.
    15 Nm (11.1 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 8 mm socket
    • Ratchet/torque wrench
    Informational PurposesAn informational icon, calling your attention
    Note
    Verify the O-ring is not damaged, replace O-ring as needed.
  2. Install the mid aero shield. See Aero Shield - Middle (Remove and Replace).