Interior Trim - Pillar and Sill Trim - A-B-C Post Interior Trim - Trunk Sill Lower Trim (Remove and Replace)
Correction code
1518010102
FRT 0.1
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Remove the LH lower A pillar trim. See A PILLAR LOWER TRIM - LEFT HAND (Remove and Install)
-
Release LH front seat harness from
sill trim clips.
NoteBe careful not to cut the wiring harness.
-
Remove front sill panel harness fastening tapes and zip ties.
NoteBe careful not to cut the wiring harness.
- Remove LH front sill panel harness from bracket.
- Remove LH front sill panel harness bracket.
Install
- Install LH front sill panel harness bracket.
- Install LH front sill panel harness to bracket.
- Tighten front sill panel harness and bracket.
-
Install clips securing LH seat harness to sill trim.
NoteTuck excess harness between harness bracket and body.
- Install the LH lower A pillar trim. See A PILLAR LOWER TRIM - LEFT HAND (Remove and Install)