2025-03-12

ROCKER CARRIER - LEFT HAND (Remove and Replace)

Correction code 1220020502 FRT 0.00 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications:ROCKER CARRIER - LEFT HAND (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x2) that attach the LH lower rocker panel cover to the body
9 Nm (6.6 lbs-ft)
  • Cordless Ratchet/Impact Driver
  • 10 mm deep socket
  • Ratchet/torque wrench
Reuse

Remove

  1. Remove the LH rocker cover from the rocker carrier. See ROCKER COVER - LEFT HAND (Remove and Replace)
  2. Remove the bolts (x2) that attach the LH lower rocker panel cover to the body.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Cordless Ratchet/Impact Driver
    • 10 mm deep socket
    • Ratchet/torque wrench
  3. Release the clips (x10) that attach the LH lower rocker panel cover to the rocker panel, and then remove the cover from the panel.

Install

  1. Install the clips (x10) that attach the LH lower rocker panel cover to the rocker panel.
  2. Install the bolts (x2) that attach the LH lower rocker panel cover to the body.
    9 Nm (6.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Cordless Ratchet/Impact Driver
    • 10 mm deep socket
    • Ratchet/torque wrench
  3. Install the LH rocker cover to the rocker carrier. See ROCKER COVER - LEFT HAND (Remove and Replace)