2025-04-13

Instrument Panel - Air Vent - Passenger - RHD (Remove and Replace)

Correction code 1405030502 FRT 1.20 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the instrument panel upper assembly. See Assembly - Instrument Panel - Upper (RHD) (Remove and Install).
  2. Disconnect the passenger air vent connectors (x2).
  3. Remove the screws (x5) that attach the passenger air vent from the instrument panel upper assembly, and release the datums (x3), and then remove the air vent from the assembly.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit

Install

  1. Position the passenger air vent to the instrument panel upper assembly and align the datums (x5), and then install the screws (x5) that attach the passenger air vent from the instrument panel upper assembly.
    0.9 Nm (8 lbs-in)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
  2. Connect the passenger air vent connectors (x2).
  3. Install the clip that attaches the passenger footwell duct to the vehicle.
  4. Install the instrument panel upper assembly. See Assembly - Instrument Panel - Upper (RHD) (Remove and Install).