2026-03-03

Cushion - Seat - 3rd Row (Model YL) (Remove and Replace)

Correction code 13060100402 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-03-03: Added circular hooks (x2) to the 3rd row seat cushion.

Remove

  1. Open the liftgate.
  2. Open the rear doors and lower the rear windows.
  3. Move the 2nd row seats forward.
  4. While pressing the LH and RH tabs towards the vertical backward of the vehicle, pull the front edge of the seat cushion up.
  5. Disconnect the seat cushion electrical connector, and then with assistance, press the rear seat cushion and lift the front seat cushion to release the circular hooks (x2).

Install

  1. Position the seat cushion in the vehicle to secure the circular hooks (x2).
  2. Connect the electrical connector of the seat cushion.
  3. Insert the seat belt buckles through the seat cushion hole.
  4. Slide the seat cushion inward, align the front tabs, and then push the seat cushion into the tabs.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure that the seat cushion is fully seated with a push and pull test.
  5. Move the 2nd row seats back to their original positions.
  6. Raise the rear windows and close the rear doors.
  7. Close the liftgate.