2025-03-12

2ND ROW ARMREST - 5-SEATER (Remove and Replace)

Correction code 1305010302 FRT 0.00 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: 2ND ROW ARMREST - 5-SEATER (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws (x2) that attach the LH and RH armrest panel cover
2.5 Nm (1.8 lbs-ft)
  • Torx T20 bit
  • Ratchet/torque wrench
Reuse
Bolts (x2) that attach the armrest lobe
8 Nm (5.9 lbs-ft)
  • Ratchet/torque wrench
  • 10 mm deep socket
Reuse

Remove

  1. Remove center backpanel from 2nd row center seatback. See SECOND ROW BACKPANEL - CENTER (Remove and Replace).
  2. Remove LH and RH armrest panel covers.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
    • Ratchet/torque wrench
  3. Remove the bolts (x2) that secure the center armrest bracket to the seat frame.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Ratchet/torque wrench
    • 10 mm deep socket
  4. Fold 20 seatback in up position.
  5. Pull armrest away from 20 seatback to release, remove from the rear downwards and forward.

Install

  1. Install armrest to 20 seatback.
  2. Fold 20 seatback in down position.
  3. Install LH and RH armrest lobe bolts (x2).
    8 Nm (5.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Ratchet/torque wrench
    • 10 mm deep socket
  4. Install screws (X2) that attach RH and LH armrest panel cover to armrest panel.
    2.5 Nm (1.8 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
    • Ratchet/torque wrench
  5. Install center backpanel to 2nd row center seatback. See SECOND ROW BACKPANEL - CENTER (Remove and Replace).