Harness - Liftgate Trim with Radio(Remove and Replace)
Correction code
TBD
FRT
0.15
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Remove the liftegate lower trim. See LIFTGATE LOWER TRIM - REAR SPEAKER (Remove and Replace).
- Disconnect the liftgate switch connector.
- Disconnect the liftgate lamp connector.
- Disconnect the liftgate speaker connectors (x2).
- Release the clip and hooks (x4) that attach the liftgate harness to the liftgate lower trim, and then remove the harness from the vehicle.
Install
- Route the liftgate harness through the NVH pad, and then install the clip and hooks (x4) that attach the liftgate harness to the liftgate lower trim.
- Connect the liftgate speaker connectors (x2).
- Connect the liftgate lamp connector.
- Connect the liftgate switch connector.
- Install the liftegate lower trim. See LIFTGATE LOWER TRIM - REAR SPEAKER (Remove and Replace).