Steering Wheel - Horn (Remove and Replace)
Correction code
3205010902
FRT
0.15
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Torque Specifications
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
Bolts (x3) that attach the steering wheel horn to the steering wheel |
![]() 3 Nm (2.2 lbs-ft) |
|
Reuse |
Remove
- Remove the driver airbag. See Airbag - Driver (Remove and Replace).
- Disconnect the steering wheel horn connector.
-
Remove the bolts (x3) that attach the
steering wheel horn to the steering wheel, and then remove the horn from the
vehicle.
TIpUse of the following tool(s) is recommended:
- 5 mm hex
Install
-
Position the steering wheel horn onto
the steering wheel, and then install the bolts (x3) that attach the steering wheel horn
to the steering wheel.3 Nm (2.2 lbs-ft)TIpUse of the following tool(s) is recommended:
- 5 mm hex
- Connect the steering wheel horn connector.
- Install the driver airbag. See Airbag - Driver (Remove and Replace).