2026-08-09

Harness - Rear Fascia (Remove and Replace)

Correction code 1710070102 FRT 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Remove

  1. Remove the rear fascia. See Assembly - Fascia and Diffuser - Rear (Remove and Install).
  2. Disconnect the electrical connectors from the LH and RH rear license plate lamp.
  3. Disconnect the electrical connectors from the LH and RH rear fascia lamps respectively.
  4. Remove LH rear fascia harness clip.
  5. Disconnect RH rear BLE connector.
  6. Remove RH rear fascia harness clip.
  7. Remove the locator hooks (x8) that attach the rear fascia harness to the vehicle.
  8. Remove the rear fascia harness.

Install

  1. Position rear fascia harness to lower rear fascia, install the hooks (x8) that attach the rear fascia harness to the vehicle.
  2. Install RH rear fascia harness clip.
  3. Connect RH rear BLE connector.
  4. Install LH rear fascia harness clip.
  5. Connect the electrical connectors to the LH and RH rear fascia lamps respectively.
  6. Connect the electrical connectors to the LH and RH rear license plate lamp.
  7. Install the rear fascia. See Assembly - Fascia and Diffuser - Rear (Remove and Install).