2025-03-12

FRONT END MODULE HARNESS (Remove and Replace)

Correction code 1710040102 FRT 0.25 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Disconnect the LV battery. See LV Power (Disconnect and Connect).
  2. Disconnect hood latch actuator connector.
  3. Disconnect hood latch connector.
  4. Disconnect active grille shutter actuator connector.
  5. Disconnect LH and RH front end carrier harness connector.
  6. Disconnect LH and RH accelerometer sensor connector
  7. Remove the ambient air temperature sensor connector. See SENSOR - AMBIENT AIR TEMPERATURE - HEATING/COOLING CIRCUIT (Remove and Replace).
  8. Release front end carrier harness clips (X6) and remove harness.

Install

  1. Position FEM harness into vehicle and secure harness clips to front end carrier.
  2. Install the ambient air temperature sensor connector. See SENSOR - AMBIENT AIR TEMPERATURE - HEATING/COOLING CIRCUIT (Remove and Replace).
  3. Connect RH and LH accelerometer sensor connector
  4. connect RH and LH front end carrier harness connector.
  5. Connect active grille shutter actuator connector.
  6. Connect hood latch connector.
  7. Connect hood latch actuator connector.
  8. Connect the LV battery. See LV Power (Disconnect and Connect).