2024-12-24

Module - BLE - Interior (Remove and Install)

Correction code TBD FRT 0.1 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Module - BLE - Interior (Remove and Install)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that attaches the BLE module to the vehicle
9 Nm (6.6 lbs-ft)
  • 10 mm deep socket
 Reuse

Remove

  1. Open the LH front door and lower the LH front window.
  2. Rotate the LH and RH sun visors away from the check bases.
    Figure 1. LH shown, RH similar
  3. Release the clips that attach the front center of the headliner to the body to gain access to the interior radar.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Take care not to bend the headliner. Replace any damaged clips.
  4. Disconnect the interior BLE module connector.
  5. Remove the bolt that attaches the BLE module to the vehicle, and then release the clip and remove the BLE module.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm deep socket

Install

  1. Seat the BLE module at the proper position, secure the clip, and then secure the bolt that attaches the BLE module to the vehicle.
    9 Nm (6.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm deep socket
  2. Connect the interior BLE module connector.
  3. Install the clips that attach the front center of the headliner to the body.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Take care not to bend the headliner. Replace any damaged clips.
  4. Secure the LH and RH sun visors to the check bases.
  5. Raise the LH front window and close the LH door.