2025-03-12

MICRO SD 16GB CARD (Remove and Replace)

Correction code 2110010202 FRT 0.15 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • Tweezers - 1126453-00-A
  • SD Card Install Guide - 1607771-00-A

Remove

  1. Open the RH front door and lower the RH front window.
  2. Move the RH front seat rearward.
  3. Disconnect LV battery power. See LV Power (Disconnect and Connect).
  4. Remove the RH front cabin carpet. See CABIN CARPET - FRONT - RIGHT HAND (Remove and Replace).
  5. Use a pick to slide the SD card retaining tab over, and then use tweezers to remove the SD card from the computer.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Make sure not to remove the SIM card, located to the left of the SD card.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Tweezers - 1126453-00-A
    • Pick Miniature Soft Grip 90 degree tip 6in
  6. Destroy the SD card by cutting the card in half through the center, and then cut each piece into half, resulting in 4 pieces.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    It is mandatory to destroy the SD card to protect user data.

Install

  1. Position the SD card into the install guide.
    Informational PurposesAn informational icon, calling your attention
    Note
    Ensure the install guide slide is in the down position. Slide the SD card into the top of the tool from left to right until fully seated.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • SD Card Install Guide - 1607771-00-A
  2. Install the SD card into the computer with the gold pads facing rearward (towards the rear of the vehicle).
    Informational PurposesAn informational icon, calling your attention
    Note
    Slide the guide locking tab upward until there is an audible click.
  3. Remove the guide and confirm the SD card is fully seated.
  4. Install the RH front cabin carpet. See CABIN CARPET - FRONT - RIGHT HAND (Remove and Replace).
  5. Connect LV battery power. See LV Power (Disconnect and Connect).
  6. Move the RH front seat to its original position.
  7. Raise the RH front window and close the RH front door.