2026-08-09

B-Cover - Inner - Inboard - 2nd Row Seat - RH (7-Seat) (Remove and Replace)

Correction code 1308020501 1308020502 FRT 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Remove

  1. Remove the 2nd row RH seat assembly. See .
  2. Use a trim tool to release the clips (x9) that attach the back panel to the seat, starting from the upper left of the seat, and then detach the hooks (x4) to remove the back panel from the 2nd row RH seat back.
  3. Remove the 2nd row RH outer B-cover. See B-Cover - Outer - Inboard - 2nd Row Seat - RH (7-Seat) (Remove and Replace).
  4. Remove the screw and clip that attach the 2nd row RH seat inboard inner B cover to the seat assembly, and then remove the inner B-cover from the vehicle.
    Tip
    Use of the following tool(s) is recommended:
    • Torx T25 socket

Install

  1. Install the screw and clip that attach the 2nd row RH seat inboard inner B cover to the seat assembly.
    1.5 Nm (1.1 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • Torx T25 socket
  2. Install the 2nd row RH outer B-cover. See B-Cover - Outer - Inboard - 2nd Row Seat - RH (7-Seat) (Remove and Replace).
  3. Install the 2nd row RH seat assembly. See .
  4. Unlock vehicle gateway. See Gateway (Unlock).
  5. Run ODIN routine PROC_VCLEFT_X_2R-SEAT-RECLINE-CALIBRATIONvia Service Mode:Low Voltage ➜ Second Row Seats ➜ Calibratevia Toolbox:(link)
  6. Perform the following routine using Service Mode or Toolbox (see 0005 - Service Modes): PROC_VCLEFT_X_2R-SEAT-RECLINE-CALIBRATIONvia Service Mode:Low Voltage ➜ Second Row Seats ➜ Calibratevia Toolbox:(link)
  7. Exit service mode.
  8. Close all four doors.