2025-01-22

Badge - Model Y+ (Remove and Replace)

Correction code TBD FRT 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

  • 1453028-00-A- Badge Removal Kit
  • 1049517-00-A - SEAM ROLLER, SILICONE, 5"
  • 2091864-00-A - REAR LEFT BADGE JIG
Informational PurposesAn informational icon, calling your attention
Note
The badge is not reusable due to the positioning problem. If the badge is removed for any reason, it must be replaced with a new one.

Remove

  1. Prepare the badge removal tool (1453028-00-A) with approximately 24 inches/60 centimeters of monofilament line.
  2. Tie slip knots at both ends of the fishing line and attach them each to the center groove of a handle.
  3. Move the badge removal tool in a sawing motion to separate the MODEL Y+ badge from the liftgate.
  4. Use IPA wipes to clean all adhesive residue and debris from the lower left liftgate surface.

Install

  1. Slowly peel the backing of the MODEL Y+ badge, then align the holes of the protective film with the location pins on the jig (2091864-00-A) to install the badge onto the jig.
  2. Adjust the liftgate to an appropriate height, and then install the jig into position on the liftgate.
    Informational PurposesAn informational icon, calling your attention
    Note
    The jig lower and left edge should be aligned with the liftgate edge. Hold on to the jig during the installation process to avoid the jig falling.
  3. Use finger to press the MODEL Y+ badge onto the liftgate, then remove the protective film and the jig.
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not discard the protective film, it will be used again in the next step.
  4. Close the liftgate, then replace the protective film over the badge, use a pressure roller (1049517-00-A) to fully adhere the badge, and then remove the protective film.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Be careful not to damage the badge during the rolling process.
  5. Use an IPA wipe to clean the badge and the area around the badge.
    Informational PurposesAn informational icon, calling your attention
    Note
    Make sure that all edges of the badge are securely affixed to the liftgate surface.