2026-09-25

Restraint Control Module (Remove and Replace)

Correction code 2020010302 FRT 1.44 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Note
For APAC vehicles produced after September 26, 2025, use correction code 2020010312. These vehicles are equipped with a newer version of the podium, which is higher than the previous version, resulting in a revised approach for accessing and removing the RCM.
  • 2026-08-14: Revised steps for APAC vehicles produced after September 26, 2025, equipped with the higher podium.
  • 2026-04-01: Updated the RCM part number location image for clarity purposes.
  • 2026-01-28: Added Note to make sure that the RCM is disarmed before removing it.
Warning
Make sure 12V/LV power has been disconnected for at least 1 minute before disconnecting the electrical harness from Supplementary Restraint System (SRS) components, such as Restraint Control Module, sensors, airbags, etc. Disconnect the 12V/LV battery and the First Responder Loop. Failure to do so can result in unintended safety system behaviors. For more information on SRS precautions, see Airbag and Supplementary Restraint System (SRS) Precautions.
Warning
Supplementary Restraint System (SRS) components can be hazardous if not handled properly. For more information on SRS precautions, see Airbag and Supplementary Restraint System (SRS) Precautions.
Warning
While performing any Supplementary Restraint System (SRS) related repairs, it is important to disconnect 12V/LV power. If the vehicle’s 12V/LV power is NOT disconnected and the Restraint Control Module is removed or disturbed, this can result in the deployment of the vehicle’s airbags.
CAUTION
Supplemental Restraint System (SRS) components can be hazardous if not serviced and handled correctly. See Airbag and Supplementary Restraint System (SRS) Precautions
CAUTION
In the event of an airbag or seatbelt pretensioner deployment, certain components must be replaced, and other components must be inspected for damage. Refer to the Collision Repair Manual for a specific list of items that must be inspected and replaced.

Install

  1. Per local legal regulations, confirm that the part number of the new restraint control module is correct.
  2. Install the restrain control module. See Restraint Control Module (Remove and Install).
  3. Reinstall the vehicle software. See Software Reinstall - Touchscreen.
  4. Unlock the vehicle gateway. See Gateway (Unlock).
  5. On the touchscreen, touch Safety & Restraints > Airbags > RCM > Post Replacement Tasks, click Run to allow the routine to run.
  6. Exit Service Mode. See Service Mode.
  7. Perform headlight adjustment and verify vehicle operation.
    Note
    Add corresponding correction code as a separate activity to the Service Visit.