2025-03-12

FIRST ROW SWITCH PACKAGE 8 WAY WITH LUMBAR - LEFT HAND (Remove and Replace)

Correction code 1301010202 FRT 0.15 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the LH front seat outboard shield. See 1ST ROW OUTBOARD SIDESHIELD - FOR LEFT HAND SEAT - LUMBAR (Remove and Replace).
  2. Remove the clips (x5) that attach the seat cushion button switch and the recliner button switch to the LH front outboard shield.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Make sure that the trim and the switch are not damaged during removal.
  3. Remove the screws (x3) that attach the 8 way and lumbar switch assembly to the LH front outboard shield, and then remove the switch.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
    • 2 in extension
    • Ratchet/torque wrench

Install

  1. Install the screws (x3) that attach the 8 way and lumbar switch assembly to the LH front outboard shield.
    0.7 Nm (6 lbs-in)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 bit
    • 2 in extension
    • Ratchet/torque wrench
  2. Install the clips (x5) that attach the seat cushion button switch and the recliner button switch to the LH front outboard shield.
  3. Install the LH front seat outboard shield. See 1ST ROW OUTBOARD SIDESHIELD - FOR LEFT HAND SEAT - LUMBAR (Remove and Replace).