2026-08-09

Rear Drive Inverter - Assembly, Fluid Coupling, VDA - 18, 55DEG, 50A. (Remove and Replace)

Correction code 4020010062 0.96 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Remove

  1. Release bolts securing LH mount assembly to rear drive unit. See Rear Drive Unit Assembly - 3DU - Drive Unit - LH Mount - 3DU (Remove and Replace).
  2. Remove bolt securing straight fluid coupling.
    Note
    Gently pry on mount upwards from the rear to assist with bolt removal.
    Tip
    Use of the following tool(s) is recommended:
    • Torx T30 socket
    • 4 in extension
  3. Remove straight fluid coupling from drive inverter assembly.

Install

  1. Install straight fluid coupling into drive inverter assembly.
    Note
    Take care not to damage the sealing ring, ensure straight fluid coupling is seated properly into drive inverter assembly.
  2. Install bolt securing straight fluid coupling.
    6 Nm (4.4 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • Torx T30 socket
    • 4 in extension
  3. Install bolts securing LH mount assembly to rear drive unit. See Rear Drive Unit Assembly - 3DU - Drive Unit - LH Mount - 3DU (Remove and Replace).