Tire Rotation (Maintenance)
Correction code 34010105 FRT 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.
Vehicle ride quality and handling are maximized when all 4 tires are the same age, model, and tread depth. Rotating tires regularly allows them to wear at the same rate and increases the service life. Tesla recommends tire rotation every 6,250 miles (10,000 km) or if tread depth difference is 2/32 in (1.5mm) or greater, whichever comes first.
Procedure
- Remove all 4 wheels. See Wheel Assembly (Remove and Install).
-
Check if the tires are offset or directional.
NoteDirectional tires are identified with an arrow indicating the direction of rotation on the sidewall.
-
Reinstall the wheels according to the type of tires.
Figure 1. Non-Directional Tires, All Tires Same Size Move front tires to opposite side in rear. Move rear tires only to front.
NoteMobile Service technicians, factory tires may be rotated as indicated in "Non-Directional Tires, Front and Rear Different Size". - Install all 4 wheels. See Wheel Assembly (Remove and Install).
- Place the vehicle in Service Mode by using the touchscreen. See Service Mode.
- Unlock the vehicle gateway. See Gateway (Unlock).
- On the touchscreen, tap the Service Mode "wrench" (at the bottom of the touchscreen UI), and then tap Run, and allow the routine to complete. , click
-
Tap Reset. After
resetting, check if the
Tire Service Mileage
in the upper right corner is displayed asLess than 500 km ago
. , choose the tire season and click - Exit Service Mode. See Service Mode.
- Close the LH front door.
- Inform the customers that a short calibration drive cycle might be required.