2026-08-09

Module - Ambient Light - Front Door - RH (Remove and Replace)

Correction code 1513021502 FRT 0.20 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Install

  1. Install the front door ambient light module. See Module - Ambient Light - Front Door - RH (Remove and Install).
  2. Unlock the vehicle gateway. See Gateway (Unlock).
  3. On the touchscreen, tap the Service Mode "wrench" (at the bottom of the touchscreen UI), and then tap Low Voltage > Interior Lighting > Address RGB Lights > Run, and allow the routine to complete.
    Note
    Make sure the vehicle firmware is version 2024.44 or later.
  4. Reinstall the vehicle firmware. See Software Reinstall - Touchscreen.
  5. Exit Service Mode. See Service Mode.