Coat Hook and Map Light - LH (Remove and Replace)
Correction code
1520010102
FRT
0.42
NOTE: Unless
otherwise explicitly stated in the procedure, the correction code and FRT
listed above reflect all of the work required to perform this procedure,
including the linked procedures. Do not stack correction
codes unless explicitly told to do so.
NOTE: See Flat Rate Times
to learn more about FRTs and how they are created.
NOTE: See Personal Protection
to make sure you are wearing proper PPE when performing the procedure
below.
NOTE:
See Ergonomic Precautions for
safe and healthy working practices.
- 2025-12-15: Added steps to run routines.
Remove
- Removed the LH coat hook and map light assembly. See Coat Hook and Map Light - LH (Remove and Install).
Install
- Install the LH coat hook and map light assembly. See Coat Hook and Map Light - LH (Remove and Install).
- Locally connect a laptop with Toolbox 3 to the vehicle. See Toolbox (Connect and Disconnect).
- In Toolbox 3.0, click the Actions tab, type "Dome Lights" into the search field, click TEST-SELF_VCLEFT_REAR-DOME-LIGHTSvia Toolbox:(link), click Run, and allow the routine to complete.
- Reinstall the vehicle software. See Software Reinstall - Touchscreen.
- Exit Service Mode or disconnect the laptop if applicable (see 0005 - Service Modes).