2025-03-12

Door Window Switch - Passenger (Remove and Replace)

Correction code 1513011502 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: Door Window Switch - Passenger (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that attaches front lower bolt cover to vehicle
6 Nm (4.4 lbs-ft)
  • Cordless Ratchet/Impact Driver
  • Ratchet/torque wrench
  • Torx T30 socket
 Reuse

Remove

  1. Open RH front door and Lower RH front window.
  2. Remove RH front lower bolt cover.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Cordless Ratchet/Impact Driver
    • Ratchet/torque wrench
    • Torx T30 socket
  3. Remove RH front window switch.
  4. Disconnect and release switch connector from RH front window switch.

Install

  1. Install RH front window switch.
    Informational PurposesAn informational icon, calling your attention
    Note
    Secure LH front window switch to door panel.
  2. Connect switch connector to RH front window switch.
  3. Install RH front lower bolt cover.
    1.2 Nm (.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Install the light to lower bolt cover first.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Cordless Ratchet/Impact Driver
    • Ratchet/torque wrench
    • Torx T30 socket
  4. Raise RH front window and close RH front door.