MOUNT ISOLATOR- FRONT UPPER CONTROL ARM - LEFT HAND (Remove and Replace)
Correction code
3115010902
FRT
0.45
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Remove the front upper control arm mount assembly from the coil damper. See Front Coil Spring and Damper - FUCA Mount, LH (Remove and Replace).
-
Remove the isolator from the front
upper control arm mount.
Install
-
Install the isolator to the front
upper control arm mount.
NoteMake sure both tabs are on position.
- Install the front upper control arm mount assembly to the coil damper. See Front Coil Spring and Damper - FUCA Mount, LH (Remove and Replace).