Puddle Lamp - Center Console (Remove and Replace)
Correction code
TBD
FRT
0.5
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Remove
- Remove the LH and RH front side panels. See CONSOLE SIDE PANEL LEFT HAND (Remove and Replace).
- Remove the sliding door assembly. See 2.0 CONSOLE - SLIDING BIN LID (Remove and Replace).
- Disconnect the puddle lamp connector.
- Use a plastic trim tool to remove the clips (x4) that attach the puddle light to the center console closeout, and then remove the puddle light from the vehicle.
Install
- Install the clips (x4) that attach the puddle light to the center console closeout.
- Connect the puddle lamp connector.
- Install the sliding door assembly. See 2.0 CONSOLE - SLIDING BIN LID (Remove and Replace).
- Install the LH and RH front side panels. See CONSOLE SIDE PANEL LEFT HAND (Remove and Replace).