2026-07-30

Cover - Busbar Module 3 To Shunt - Ancillary Bay (Model Y L) (Remove and Replace)

Correction code 16300502202 FRT 2.52 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Remove

  1. Remove the PCS2 Lite. See PCS2 Lite - Ancillary Bay (Model YL) (Remove and Install).
    Informational PurposesAn informational icon, calling your attention
    Note
    During removal, certain steps require extra care. See the animation(s) for detailed guidance.
  2. Remove the HV joint insulator for negative busbar module 3 to shunt.
  3. Release the clips (x3) securing the negative busbar module 3 to shunt cover.