2026-08-09

Wiper Module - RHD (Remove and Install)

Correction code 1750020701 FRT 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2026-05-13: Added pinch point warning.
Table 1. Torque Specifications: Wiper Module - LHD (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x2) that attach the wiper module to the vehicle
9 Nm (6.6 lbs-ft)
  • 10 mm socket
Reuse

Remove

  1. Remove the cowl screen panel. See Cowl Screen (Remove and Replace).
  2. Remove the bolts (x2) that attach the wiper module to the body.
    Tip
    Use of the following tool(s) is recommended:
    • 10 mm socket
  3. Carefully pull the wiper module towards the front of the vehicle to release the rubber anchor from the bracket on the bulkhead.
  4. Disconnect the electrical connector from the wiper module, and then remove the wiper module from the vehicle.

Install

  1. Carefully move the wiper module towards the rear of the vehicle, to align the rubber anchor with the bracket on the bulkhead.
  2. Connect the electrical connector to the wiper module.
    Warning
    Keep your fingers away from any potential pinch points and moving parts while connecting and installing the wiper module. Do not attempt to test the module until it is fully installed in the vehicle.
    CAUTION
    Check the harness to make sure it is routed correctly.
  3. Install the bolts (x2) that attach the wiper module to the body.
    9 Nm (6.6 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 10 mm socket
  4. Install the cowl screen panel. See Cowl Screen (Remove and Replace).