2025-03-12

MOLDING -SHOCK TOWER COVER - RIGHT HAND (Remove and Replace)

Correction code 1225010502 FRT 0.10 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
  2. Remove the cowl screen RH side retaining clip.
  3. Release the harness clip from the RH shock tower cover.
  4. Release the clips and lift the cowl screen to remove the RH shock tower cover.

Install

  1. Lift the cowl screen to install the RH shock tower cover, and then secure the clips.
  2. Install the harness clip to the RH shock tower cover.
  3. Install the cowl screen RH side retaining clip.
  4. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).