2025-03-12

COWL SCREEN BRACKET (Remove and Replace)

Correction code 1010040102 FRT 0.20 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications: COWL SCREEN BRACKET (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Stud bolt that attaches the positive jumper post to the cowl screen bracket
8 Nm (5.9 lbs-ft)
  • External Torx E5
  • Torque wrench with angle measurement
Reuse
Bolt that attaches the cowl screen bracket to the body
7 Nm (5.2 lbs-ft)
  • 10 mm deep socket
  • Torque wrench with angle measurement
Reuse

Remove

  1. Remove the cowl screen panel. See COWL SCREEN (Remove and Replace).
  2. Remove the positive jumper post cap.
  3. Remove the stud bolt that attaches the positive jumper post to the cowl screen bracket.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • External Torx E5
    • Torque wrench with angle measurement
  4. Remove the bolt that attaches the cowl screen bracket to the body.
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • 10 mm deep socket
    • Torque wrench with angle measurement
  5. Release the tabs (x2) that attach the cowl screen bracket to the vehicle, and then remove it from the vehicle.

Install

  1. Install the tabs (x2) that attach the cowl screen bracket to the vehicle.
  2. Install the bolt that attaches the cowl screen bracket to the body.
    7 Nm (5.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • 10 mm deep socket
    • Torque wrench with angle measurement
  3. Install the stud bolt that attaches the positive jumper post to the cowl screen bracket.
    8 Nm (5.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    Use of the following tool(s) is recommended:
    • External Torx E5
    • Torque wrench with angle measurement
  4. Install the positive jumper post cap.
  5. Install the cowl screen panel. See COWL SCREEN (Remove and Replace).