2025-03-12

2ND ROW SEAT 5 SEATER - 60 (Remove and Replace)

Correction code 1305010502 FRT 0.00 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. If equipped, remove the parcel shelf. See PARCEL SHELF (Remove and Replace).
  2. Remove the 2nd row seat cushion. See 2ND ROW SEAT CUSHION (Remove and Replace).
  3. Remove the lower C-pillar trim. See Trim - C-Pillar - Lower - LH (5-Seat) (Remove and Replace).
  4. Remove the clips (x3) that attach the rear main cabin carpet to the vehicle.
  5. Remove and discard the bolts (x5) that attach the 2nd row LH seat frame to the body.
    Informational PurposesAn informational icon, calling your attention
    Note
    The bottom seat bolts are located behind the main carpet.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 11 mm socket
    • Flex head ratchet/flex head torque wrench
    • Cordless Ratchet/Impact Driver
  6. Disconnect the 2nd row LH seat connector.
  7. Fold the 2nd row RH seat back down.
  8. With assistance, remove the 2nd row LH seat assembly from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Set the 2nd row LH seat assembly onto the rear load floor, and then remove the seat assembly from the rear side of the vehicle. Use fender cover to avoid damaging trims.

Install

  1. With assistance, install the 2nd row LH seat assembly onto the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Set the 2nd row LH seat assembly onto the rear load floor through the rear side of the vehicle, and then install the seat assembly onto the body. Use fender cover to avoid damaging trims.
  2. Return the 2nd row RH seat back to vertical position.
  3. Install new bolts (x5) to attach the 2nd row LH seat frame to the body. Torque the bolts in sequence of outboard front, inboard rear (x2), outboard rear, and then inboard front.
    37 Nm (27.3 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    Note
    The bottom seat bolts are located behind the main carpet.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 11 mm socket
    • Flex head ratchet/flex head torque wrench
    • Cordless Ratchet/Impact Driver
  4. Connect the 2nd row LH seat connector.
  5. Install the clips (x3) that attach the rear main cabin carpet to the vehicle.
  6. Install the lower C-pillar trim. See Trim - C-Pillar - Lower - LH (5-Seat) (Remove and Replace).
  7. Install the 2nd row seat cushion. See 2ND ROW SEAT CUSHION (Remove and Replace).
  8. If equipped, install the parcel shelf. See PARCEL SHELF (Remove and Replace).