2026-08-09

Side Door Striker (Remove and Replace)

Correction code 1133020302 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Torque Specifications

Table 1. Torque Specifications: Side Door Striker (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolts (x2) that attach the LH front door striker to the body
24 Nm (17.7 lbs-ft)
  • Torx T40 socket
 Reuse

Remove

  1. Open the LH front door and lower the LH front window.
  2. Mark the position of the LH front door striker using masking tape.
  3. Remove the bolts (x2) that attach the LH front door striker to the body.
    Tip
    Use of the following tool(s) is recommended:
    • Torx T40 socket
  4. Remove the LH front door striker from the vehicle.

Install

  1. Hand-tighten the bolts (x2) that attach the LH front door striker to the body.
  2. Close the LH front door and verify the door position; adjust the position of the striker and verify fitment, if necessary.
  3. Tighten the bolts (x2) that attach the LH front door striker to the body.
    24 Nm (17.7 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • Torx T40 socket
  4. Remove the masking tape from the body.
  5. Raise the LH front window and close the LH front door.