2024-11-11

Blower - Cushion - Front Seat - LH (Remove and Replace)

Correction code 1301021102 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.NOTE: See Ergonomic Precautionsfor safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Seat base edges are sharp and can cause personal injury. Wear cut resistant gloves when removing the seat from the vehicle, and while performing procedures that involve work on or near the seat base.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Move the driver seat fully forward.
  3. Disconnect the seat cushion blower connector.
  4. Press to release the clips (x2) that attach the driver seat cushion blower to the driver seat frame, and then remove the blower from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pay attention not to damage the guide tab.

Install

  1. Insert the guide tab into the guide card slot, and then fasten the clips (x2) that attach the blower to the driver seat frame.
  2. Connect the electrical connector to the driver seat cushion blower.
  3. Move the driver seat to its original position.
  4. Raise the LH front window and close the LH front door.