AUDIO AMPLIFIER (Remove and Install)
Correction code
2121010201
FRT
0.20
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com.
NOTE: See Personal Protection to make
sure wearing proper PPE when performing the below procedure.
Torque Specifications
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
Bolt that attaches the audio amplifier to the body |
![]() 6 Nm (4.4 lbs-ft) |
|
Reuse |
Remove
- Remove the RH trunk side trim. See TRUNK SIDE TRIM LEFT HAND - REAR UNDER BODY (Remove and Replace).
- Disconnect the connectors (x3) from the RH rear audio amplifier.
-
Remove the bolt that attaches the
audio amplifier to the body, and then remove the audio amplifier from the vehicle.
TIpUse of the following tool(s) is recommended:
- 10 mm deep socket
Install
-
Insert the tabs (x2) of the amplifier
into the slots and then install the bolt that attaches the audio amplifier to the
body.6 Nm (4.4 lbs-ft)TIpUse of the following tool(s) is recommended:
- 10 mm deep socket
- Connect the connectors (x3) to the RH rear audio amplifier.
- Install the RH trunk side trim. See TRUNK SIDE TRIM LEFT HAND - REAR UNDER BODY (Remove and Replace).