2025-10-27

Door Trim Tweeter - Front - LH (Remove and Replace)

Correction code 1513011202 FRT 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2025-10-20: Added a note to ensure that the harness and connector are fully tucked within the door trim for proper installation.

Remove

  1. Open the LH front door and lower the LH front window.
  2. Pull straight up to release the clips (x2) and locating tab that attach the LH front door tweeter assembly to the door panel.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Do not pull the tweeter assembly too far from the door panel, as the tweeter electrical connector is still attached.
  3. Disconnect the LH tweeter connector and the blind spot collision warning device connector.
  4. Use a small flat head screwdriver to release the clip, and then remove the LH tweeter from the LH front door panel.

Install

  1. Install the clip that attaches the LH tweeter to the LH front door panel.
  2. Connect the LH tweeter connector and the blind spot collision warning device connector.
  3. Align the locating tab and then pull straight down to install the clips (x2) that attach the LH front door tweeter assembly to the door.
    Informational PurposesAn informational icon, calling your attention
    Note
    Ensure that the harness and connector are fully tucked within the door trim.
  4. Raise the LH front window and close the LH front door.