2025-01-05

Side Cover Spoiler - LH (Remove and Replace)

Correction code TBD FRT 0.05 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Torque Specifications

Table 1. Torque Specifications:Side Cover Spoiler - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Smaller bolt that attaches the LH side cover spoiler to the liftgate
2.5 Nm (1.8 lbs-ft)
  • Torx T25 socket
  • Ratchet/torque wrench
Reuse
Larger bolt that attaches the LH side cover spoiler to the liftgate
4 Nm (2.9 lbs-ft)
  • Torx T30 socket
  • Ratchet/torque wrench
Reuse

Remove

  1. Open the liftgate.
  2. Remove the smaller bolt that attaches the LH side cover spoiler to the liftgate.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T25 socket
    • Ratchet/torque wrench
  3. Remove the larger bolt that attaches the LH side cover spoiler to the liftgate, and then remove the spoiler from the vehicle.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T30 socket
    • Ratchet/torque wrench

Install

  1. Position the LH side cover spoiler to the vehicle, and then install the larger bolt that attaches the spoiler to the liftgate.
    4 Nm (2.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T30 socket
    • Ratchet/torque wrench
  2. Install the smaller bolt that attaches the LH side cover spoiler to the liftgate.
    2.5 Nm (1.8 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T25 socket
    • Ratchet/torque wrench
  3. Close the liftgate.