2025-03-12

INSTRUMENT PANEL - STEERING COLUMN GAP HIDER - LOWER (Remove and Replace)

Correction code 1405011702 FRT 0.45 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure.

Remove

  1. Remove the steering column control module. See STEERING COLUMN CONTROL MODULE (Remove and Install).
  2. Remove bolts securing gap hider lower from steering column.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T25 socket
  3. Remove gap hider lower from steering column

Install

  1. lnstall gap hider lower to steering column.
  2. Install bolts securing gap hider lower to steering column.
    1.4 Nm (1.0 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T25 socket
  3. Install the steering column control module. See STEERING COLUMN CONTROL MODULE (Remove and Install).