2025-03-12

Carbon Filter (Remove and Replace)

Correction code 1810010202 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and FRT listed above reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Torque Specifications

Table 1. Torque Specifications: Carbon Filter (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws (x10) that secure the HEPA filter assembly cover
2.4 Nm (1.8 lbs-ft)
  • Torx T20 socket
  • Cordless Ratchet/Impact Driver
  • Wiha Torque Screwdriver 0.8-5 Nm screwdriver (installation only)
 Reuse

Remove

  1. Remove the HEPA filter assembly. See HEPA Filter Assembly (Remove and Replace).
  2. Remove the screws (x10) that secure the HEPA filter assembly cover.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
    • Cordless Ratchet/Impact Driver
    • Wiha Torque Screwdriver 0.8-5 Nm screwdriver (installation only)
  3. Remove the carbon filters.

Install

  1. Install the carbon filters.
    Informational PurposesAn informational icon, calling your attention
    Note
    Pay attention to the installation direction.
  2. Install the screws (x10) that secure the HEPA filter assembly cover.
    2.4 Nm (1.8 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 socket
    • Cordless Ratchet/Impact Driver
    • Wiha Torque Screwdriver 0.8-5 Nm screwdriver (installation only)
  3. Install the HEPA filter assembly. See HEPA Filter Assembly (Remove and Replace).